Working time for this glue is very fast, about 2-3 mins and quickly turns into a gooey gel. Fully set in about 5 mins so you need to work fast. It gets fairly hot when curing to the point where it starts smoking if you mix up alot in one go and it has a very bad smell, other than that i have tested this glue and it is excellent and is slightly more flexible than epoxy. I have used many glue's on PLA for those that do 3d printing and i have found if is far better than Epoxy, CA super glue, contact cement etc....Best glue for PLA bonding 5 stars.

Working time for this glue is very fast, about 2-3 mins and quickly turns into a gooey gel. Fully set in about 5 mins so you need to work fast. It gets fairly hot when curing to the point where it starts smoking if you mix up alot in one go and it has a very bad smell, other than that i have tested this glue and it is excellent and is slightly more flexible than epoxy. I have used many glue's on PLA for those that do 3d printing and i have found if is far better than Epoxy, CA super glue, contact cement etc....Best glue for PLA bonding 5 stars.

Working time for this glue is very fast, about 2-3 mins and quickly turns into a gooey gel. Fully set in about 5 mins so you need to work fast. It gets fairly hot when curing to the point where it starts smoking if you mix up alot in one go and it has a very bad smell, other than that i have tested this glue and it is excellent and is slightly more flexible than epoxy. I have used many glue's on PLA for those that do 3d printing and i have found if is far better than Epoxy, CA super glue, contact cement etc....Best glue for PLA bonding 5 stars.

O.K. a parte odore molto forte

O.K. a parte odore molto forte

O.K. a parte odore molto forte